top of page

How to fly a B-2 bomber

Writer's picture: Adyan IslamAdyan Islam

Sooo, you guys should be familiar with GeoFS. Well, in the Community Contributed section, there's a B-2 bomber addon. Let's go over how to fly it.


  1. Take-off

Number 1: DO NOT go into cockpit mode, cause its.... y'know, completely TRASH?!?! Anyway, get the flaps out and set the throttle to 70%-100%, and once you're at 150 knots, take off. Climb to an altitude of up to 40,000 feet and turn on the AP.


2. Bombing


The x funtion of the GeoFS B-2 opens the bomb bay doors. While the x function cannot be used to actually drop bombs and alter the scenery, you can pretend that is is dropping bombs



3. Landing


The B-2 is a relatively easy plane to land. Just get the landing gear out, and land. One strange thing about the GeoFS B-2 is that the airbrakes, a.k.a the spoilers produce enough drag to like stall the plane in like 3 seconds in the air and the ground, but when used in combination with the wheel brakes, it just barely produces enough drag.



Sorry for not writing for so long!

Sorry for the low-res picture. All I could find!



3 views0 comments

Recent Posts

See All

How to perform a full flight in GeoFS

I've been doing full flights in GeoFS for a few weeks. At first I used to fly the Dhaka-Chittagong-Dhaka route. Then I flew the New...

Comments


Subscribe Form

Thanks for submitting!

  • Facebook
  • Twitter
  • LinkedIn

©2021 by The Aviator. Proudly created with Wix.com

Always remember that a good pilot is always learning!

bottom of page